CL10B104KB8NNNC Datasheet

The CL10B104KB8NNNC Datasheet is a critical document for engineers and hobbyists alike, providing essential specifications and performance characteristics for a specific type of multilayer ceramic capacitor (MLCC). Understanding this datasheet is crucial for selecting the correct component for your electronic circuits, ensuring optimal performance and reliability. This article will delve into the key aspects of the CL10B104KB8NNNC Datasheet, breaking down the jargon and illustrating its practical applications.

Decoding the CL10B104KB8NNNC: A Deep Dive

The CL10B104KB8NNNC is a specific part number that uniquely identifies a particular ceramic capacitor. The datasheet associated with this part number outlines everything you need to know, from its capacitance and voltage rating to its operating temperature range and physical dimensions. Essentially, it’s the comprehensive blueprint for the capacitor. Understanding the datasheet helps prevent costly mistakes and ensures that the capacitor operates safely and effectively within your circuit design. Here’s a breakdown of some key elements you’ll find:

• Capacitance: This specifies the capacitor’s ability to store electrical charge, measured in Farads (F). The CL10B104KB8NNNC likely refers to a 0.1μF (microFarad) capacitor, given the ‘104’ code.
• Voltage Rating: This indicates the maximum voltage that can be safely applied across the capacitor. Exceeding this voltage can lead to component failure.
• Temperature Coefficient: This describes how the capacitance changes with temperature.

These datasheets are fundamental in various applications. Consider a scenario where you’re designing a power supply. You need capacitors for filtering and smoothing the DC voltage. Selecting the wrong capacitor, even with the correct capacitance value, can have severe consequences. For instance, if you choose a capacitor with an insufficient voltage rating, it could overheat and fail, potentially damaging other components in your circuit. The datasheet ensures you select a capacitor that can withstand the voltage stresses of your application. Likewise, the operating temperature range ensures the capacitor functions reliably in your target environment, preventing failures in extreme conditions. Another scenario would be using the capacitor for decoupling purposes.

1. Bypass capacitor selection.
2. Timing circuits.
3. Filtering.

Furthermore, datasheets often include performance graphs, such as impedance vs. frequency curves, which are crucial for high-frequency applications. These graphs help you understand how the capacitor will behave at different frequencies, allowing you to optimize your circuit’s performance. The physical dimensions detailed in the datasheet are also important for PCB layout and component placement. Ensuring that the capacitor fits properly on the board and has adequate spacing for heat dissipation is essential for reliable operation. The table shown below show some properties that engineers need to consider when looking at a datasheet.

Ready to delve deeper into the specifics of the CL10B104KB8NNNC? Consult the original datasheet for the most accurate and up-to-date information. It contains all the detailed electrical characteristics and performance curves you’ll need.